Heavy-gauge vapor barriers, sealed foundation vents, and a dedicated sump discharge line so your Hyattsville, MD crawl space stops feeding moisture into the floor joists above it.
A rushed encapsulation job with unsealed seams or unwrapped piers looks fine on day one and fails within a season. We treat seam sealing and pier wrapping as core parts of the install, not optional add-ons that get skipped to save time.
Every crew member is trained specifically on liner installation, seam sealing, and vent encapsulation, not general basement work.
Our technicians carry encapsulation materials on the truck for most standard-size crawl spaces, cutting down on return visits.
Pricing is based on your crawl space's actual square footage and condition, quoted in writing before liner installation begins.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
We scope every Crawl Space Encapsulation job in person before quoting it, since two properties with the same symptom rarely need the same fix.
Before any liner goes down, we pump out existing standing water and remove debris left behind by prior drainage failures.
Liner thickness is selected based on foot traffic and how the space will be used going forward, not a flat default.
Sealed vents are paired with mechanical dehumidification so the space doesn't just trap humidity instead of venting it.
We route discharge lines well away from the foundation so pumped water doesn't just cycle back in.
We also check subfloor insulation for water damage and replace anything compromised before closing the liner.
This helps us bring the right liner thickness and dehumidifier size on the first visit.
We take humidity and moisture readings to establish a baseline before recommending a system.
We explain trade-offs between liner thickness options so you can choose what fits your budget and goals.
We re-test humidity after installation to confirm the space is holding at a healthy level before we consider the job done.
"Our crawl space had standing water and a mold smell we couldn't get rid of no matter what we tried. Full encapsulation with a dehumidifier fixed it in one visit."
— Hyattsville Homeowner
"Sump discharge from the old system was dumping water right back next to the foundation. They rerouted it and the crawl space finally dried out."
— Hyattsville Customer
"They caught duct condensation we didn't even know was happening down there. Sealed everything up during the same visit."
— Hyattsville Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— Hyattsville Customer
A vapor barrier is just the liner on the ground; full encapsulation seals vents, walls, and often adds a dehumidifier for complete moisture control.
Most residential spaces do well with a 12-15 mil liner; spaces used for storage or with foot traffic often need 20 mil for durability.
Some jurisdictions have code requirements around vent sealing, which we'll flag during the inspection if relevant.
If the smell persists after encapsulation, that usually points to a separate moisture source we'd need to investigate.
Standing water doesn't disqualify a space from encapsulation; it's just the first step in the process.
Spaces with extensive prior water damage or debris may take longer — we'll give you a realistic estimate up front.
We encapsulate crawl spaces throughout Hyattsville and the surrounding Hyattsville, MD service area, including the zip codes listed below.
Zip codes we serve in Hyattsville, MD: 20781 20782 20788 20783 20785 20784
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
